flip flop popper

I thought I’d done this before … but I can’t find it.  Since there was a recent thread about “getting into making poppers”, I figured this cheap way of making them could be useful, to other cheap bass-turds like myself.

I use popper hooks – but you could use straight shanks, since the thread will make a glue base anyway.

Start thread, wrap back and tie in tail material.

2 add tail.JPG

 

Tie in leg material of choice … I am using rubber legs for this one.

3 add legs.JPG

 

After punching out a body from flip flops, you’ll need to measure it, cut it and “skewer” it.  If you push hard when punching the body, it will “deform” and have a slight taper in it.

4 adjust body.JPG

 5 trim and skewer.JPG

 

 

Using a large sewing needle, pull leg material through the foam.  A drop of superglue, then pull into final position.

6 sew and glue legs.JPG

 

Apply superglue to the threads and slide the body into place.

7 apply super glue.JPG

 8 slide on body.JPG

 

Trim legs to your desired lengths.

9 trim legs.JPG

 

When the foam body gets too chewed up by attacking fish … cut it off and glue on a new body.

re-body.JPG

The post flip flop popper appeared first on Fly Fishing Digest.

Continue reading

Popper Flies

Back in July a buddy of mine asked me to tie him some poppers, real froggy looking ones. Since I tie mostly dry flies and nymphs for trout this was a nice little challenge. He fished with them all summer and got some nice bass, but had problems getting…

Continue reading